|Colour||As per Sample|
|Finish||Smooth & Eggshell|
|Viscosity By Ford cup no. B4||110 +/- 5 sec|
|Solid Content||Approx. 48% By Volume|
|Flash Point||Not Below 30 degree centigrade.|
|Recommended DFT||40 +/-5 Microns per coat|
|Covering Capacity||90-120 Sq. ft./ ltr/ 2 coats at 35 micron DFT|
|Grinding||+7 on Hegmen Gauge|
|Specific Gravity||1.1 +/- 0.1 kg/ltr.|
|Method of Application||Brush / Spray/ Roller|
|Recommended Thinner||SP-C.R Thinner|
|Drying time||SD- Approx. 20 Minutes at 30 Degree Centigrade, HD- Approx. 2 Hours at 30 Degree Centigrade,TF- Over|
|Re-Coating Period||Not more than 4 hours|
|Self Life||Minimum 12 Months Provided components are unmixed and store in sealed container|
|Storage||Store in cool dry place|
|Disposal||Dispose in land filling and not in drain or any water canal|
|Resistance to Acid||Passes the Test|
|Resistance to Alkali||Passes the Test|
|Resistance to water||Passes the Test|
|Pack offered||20 Ltr.|
“SP-RUBBER COAT 33” is a single pack air drying chlorinated rubber based finish paint. It Gives Eggshell finish, Tough, Rust Preventing Coating, Good Abrasion Resistance, Good Chemical Resistance, Good Impact Resistance, Excellent Flexibility. It is specially designed for saline environments. This product is also recommended to be used during monsoon season or cold temperature but not to be applied under running water.
Area of Application:
Direction For Use:
Surface to be painted should be dry and free from oil, grease, dust, rust and other contaminants. This can be done by wire brush, Emery Paper, Scrapping Tools.
Apply 2 Coats of Primer On Surface after surface preparation with Interval of overnight. Sand the Surface and wipe it clean. Use Chlorinated Rubber primer for this application. Other primer may also be used after consulting with us.
Top Coat Application
Apply top coat ‘SP-RUBBER COAT 33 “with interval of 6-8 hours. Apply minimum 2 Coats on surface.
Roller or brush: can also be used. However, additional coats may be required to be applied to get desired DFT. This method of application is suitable at weld-seams, edges, corners, rivets, Stripe coating etc